PW Data Modes ESP8266 Correction

 

PW Data Modes Fig 6 Corrected

I made a mistake in the diagram pin numbering showing the serial connection to the Olimex ESP8266-DEV board. The ground should connect to pin 2 as shown using the numbering in the revised Fig.6.

Apologies for the error,

 

Mike

 

2 Responses to PW Data Modes ESP8266 Correction

  1. Laurence (G2DD) September 22, 2015 at 9:20 pm #

    Hi Mike I love the series in PW so don’t stop ! I saw your comment about the ground
    pin on the OLIMEX ESP8266 and checked my board and the GND pin is pin 2 on the UEXT
    connector. PIN 1 being shown as 3.3V. My board is an OLIMEX ESP8266-EVB-BAT so may be its different ?

    Anyway cheers

    Laurence

    • admin September 25, 2015 at 4:30 pm #

      Hi Laurence, Glad you’re enjoying the articles. It seems I made a mess of the pin numbering!! I’ve now updated my post with a new version of Fig 6 that should be correct.

      Regards,

      Mike

Leave a Reply

Powered by WordPress. Designed by WooThemes